The comparator is a high-gain amplifier that is used to amplify a small differential signal at its input, and drive the output to one of two output states. Figure 1 shows the basic comparator circuit, ...

It is a running gag around here that whenever a project posts, someone will inevitably point out that it could have been done ...

The bistable load switch is made on two comparators. The load is switched on and off sequentially by applying a voltage of two different levels to the input of the device. Earlier in [1], a new class ...

This file type includes high-resolution graphics and schematics when applicable. A colleague asked for the measured jitter number on a single-supply comparator design based on the LM359 IC. 1 He ...

Voltage comparators began appearing in single-chip microcontrollers (MCUs) in the late 1990s. At the time, the change was viewed as a simple cost reduction. Comparators required less silicon, while ...

My hands-on introduction to operational amplifiers was in 1969 while in the army as a junior scientist in the Atmospheric Science Laboratory at the White Sands Proving Grounds. We had taken a ...

Claimed to be the industry’s smallest, Maxim‘s MAX906x comparators are available in a 1x1mm four bump package. MAX9060-MAX9064 operate from 0.9 to 5.5V, and draw under 350nA for the single comparator ...